Graphics Resolution:
360 x 360 dpi maximum (24 dot, hex density)
Resident Fonts:
Courier, Gothic, Orator, Prestige, Roman, Swiss, Swiss Bold
Print Quality
Near Letter Quality:
Courier, Gothic, Orator, Prestige, Roman, Swiss, Swiss Bold
Utility/Draft Mode:
Gothic
Reliability:
Mean Time Between Failures (MTBF): 10.000 hours at 25% duty cycle and 35% page density.
Mean Time to Repair (MTTR): 30 Minutes
Print Head Life: 300 Million Characters
Print Head Replacement Instructions
CAUTION:
The print head will be hot immediately after printing. To prevent burns, do not touch it until it cools. Be sure to turn off the power switch prior to disassembly.
(1) Start up in gap fully open mode
(2) Remove the ribbon guide and the head fan assembly
(3) Open the head clamp (1) in the direction indicated by the arrow, and disconnect the print head (2) from the connector (3).
(4) Perform installation in the reverse order of removal.
(Precautions on Installation)
1. Securely insert the print head into the connector. Close the head clamp tightly.
2. Be careful not to drop the print head toward the platen side (to prevent deformation of the ribbon protector).